Sonnen sonnenBatterie pro 2.0, Instructions For Use Manual

Page: 12 / 16

4 | Electrical installation
12 / 16 Instructions sonnenBatterie pro 2.0
4.4 Electrical connection
4.4.1 Connecting the mains line
Observe the following points:
• The mains connection must be protected with a type B miniature circuit breaker, rated
current 13 A or 16 A.
• The cable cross-section from the miniature circuit breaker to the electrical consumer
must be adapted to suit the larger loads if necessary.
„
Connect the mains line as described in the installation instructions for the eco 8.0 stor-
age system (section ‘Connecting the mains line’).
4.4.2 Connecting the Ethernet lines
The connection to the customer router is established via a switch. If the customer router
has a sufficient number of free slots, the three storage systems can be connected directly
to the router. A switch is not necessary in this case.
„
Connect the Ethernet lines as shown in figure System components [P. 8]. The Ethernet
cables, the switch and the router are not included in the scope of delivery.
„
The required output type can be found in section ‘Connecting the Ethernet cable’ in
the storage system installation instructions.
4.4.3 Connecting the Modbus line
„
Connect the Modbus cable as shown in figure System components [P. 8].
4.4.4 Connecting the signal line
„
Connect the signal cable to the master as described in the storage system installation
instructions.