Mounting hole spacing
(center-to-center)
Connector Mounting Hole Spacing
2ft
3ft
4ft
24”
36”
48”
Luminaire Size Small-Small
Connector Sizes
24 3⁄8”
36 3⁄8”
48 3⁄8”
Small-Large
24 ¾”
36 ¾”
48 ¾”
Large-Large
B
F
H
D
G
C
E
A
Fig. 7
Table 1
J
July 7, 2020
©2020 SONNEMAN - A Way of Light
5 of 7
Connector Installation
Power Feed Connector with Outlet Box Driver
-
Shown with 23CxxE111 (Fig. 7)
1. Shut off power to the outlet box (A).
2. Make appropriate electrical connections using wire nuts:
a. Connect the LED driver’s (B) live wire to the live outlet box (A) wire.
b. Connect the LED driver’s neutral wire to the neutral outlet box wire.
c. Connect outlet box ground wire (green or uncoated) to the crossbar (C) using the green screw.
d. Pass Connector wires through center hole of crossbar.
e. Connect the LED driver's positive (+) output wire to the red connector wire.
f. Connect the LED driver's negative (-) output wire to the black connector wire.
g. Carefully place driver and connections in outlet box.
3. Install cross bar (C) to outlet box using outlet box screws (D).
4. Using included Allen key (J), loosen set screws (E) and remove Connector (F) from mounting bracket (G).
5. Secure canopy to mounting surface by screwing canopy nipple (H) into center hole of crossbar (C).
Note:
Hold Connector (F) and keep wires slack. Do not allow wires to twist while screwing on canopy.
6. Place Connector (F) on mounting bracket (G) and secure by tightening set screws (E) using included Allen key.
System Installation
General steps for any configuration
1. Measure and mark the locations of all Connectors on the mounting surface. Refer to Table 1 for Connector spacing.
2. Install power feed Connector(s) in desired location(s) as shown on pages 5-6.
3. Install a neighboring Connector as shown on page 6.
4. Install Luminaire between Connectors as shown on page 7.
5. Repeat steps 3-4 for all remaining Connectors and Luminaires.
6. Restore power to the outlet box or branch circuit.
