www.sonlux.de
4 / 12
www.sonlux.de
9 / 12
Security Check
Be sure to check the device for damage before use. If any damage is found, stop use
immediately and return to dealer for repair.Use the original packaging or suitable transport or
storage packaging to optimally protect the product from influences such as dust, moisture,
etc. when not in use.
Assembly of the Stand
To spread out the tripod legs, first loosen the locking screw (1) and pull out the fixing bolts (2).
Insert the fixing bolts at the desired height into the hole in the stand rod and tighten the
locking screw again.
Before using the tripod, check that all locking screws and fixing bolts are tight.If the tripod is
to be set up on stairs or another uneven surface, first loosen the locking button (3)
and pull out the fixing bolt (4).Extend the tripod leg until the desired position is reached.
Now put the fixing bolt back into the hole in the tripod leg and tighten the locking knob again.
Height Adjustment
Use the hand crank with cable pull to adjust the height.First loosen the locking screw of the
upper telescopic mast
(5)
and pull out the fixing bolt
(6)
.Tighten the other locking screw
(7)
to ensure correct stroke sequence:
The upper small mast must be raised first, followed by the larger mast!
Now turn the hand crank
(8)
clockwise to raise the upper mast.
Once the desired height is reached, insert the locating bolt into the hole in the pole and
retighten the set screw.Repeat the steps with the other mast: first loosen the locking screw
of the telescopic mast
(7)
and pull out the fixing bolt
(9)
.
Turn the crank counter-clockwise a little to avoid the rope carrying any load.
Disassembly the Stand
To disassemble the tripod, lower the heights of the telescopic masts to the minimum height
and ensure all mounting bolts are in the down position of the holes and all set screws
are tightened. The steel cable must be correct andfully rolled up to avoid crushing the fibers.
Then loosen the set screw and pull out the mounting bolt.Then pull the tripod legs back
together to form the tripod rod and insert the fixing bolt, then tighten the locking screw again.
The tripod can be transported in a vertical or horizontal position.
Intended Use
The "LightmaXX" crank tripod is used to hold SONLUX work lights and large-area lights.
The tripod may only be operated for this purpose and in accordance with the operating
instructions. A use of the tripod with noapproved accessories is expressly prohibited!
The lights must be attached in accordance with the information in this manual.
If necessary, set up a second, independent safeguard for the light, e.g. with a safety rope.
Other uses, as well as operation under other operating conditions, are expressly not intended
and can lead to property damage or personal injury! No liability is accepted for damage
resulting from improper use.It must be ensured that the device is only operated by trained and
competent users who are in full possession of their mental, physical and sensory abilities.
Use by other persons is expressly only permitted at the request of a person responsible for
their safety who instructs or supervises use
F > 70 N
KLICK!
1.
2.
2
3
4
5
open
close
ouvrir
fermer
7
Maintenance
Remove dirt and grime from the tripod after each use. Do not expose the tripod to
permanent moisture!
Maintenance and service are only to be carried out by authorized personnel.
The service of unauthorized personnel or use ofnon-approved spare parts are not permitted.
Failure to do so will void the warranty!
Instruction:
+
Instruction:
+
