SONIXX X-TOUCH, Operating Instructions Manual

Page: 5 / 30

5
ENGLISH
QUICK START
Note:
The X-Touch will also enter pairing mode if it cannot connect to any previously paired
devices.
CHARGING AND AUDIO ONLY MODE
Connect the USB cable to the spare USB port of any PC or Mac with the Micro-USB
connector plugged into the charging socket on the headphones. A full charge from
a flat battery should take approximately 2-3 hours. The indicator on the right side of
the earcup lights up red to indicate that the headset is charging. Once charging is
complete, the indicator light will turn off.
When the battery is flat you can still use the X-Touch via the included audio cable,
however the X-Touch swipe controls and telephone features are no longer active.
SWITCHING ON/OFF
Press and hold the MFB for 2 seconds to switch the X-Touch on, continue to hold for a
further 2 seconds to enter pairing mode.
Press and hold the MFB for 4 seconds to switch the headphones off, pressing and
holding for 2 seconds will activate voice control on your smartphone.
WEARING THE X-TOUCH
Adjust the band without forcing it, so that the headphones will fit comfortably over
your ears. Use the letters L and R on the inside of the headphones to distinguish
between left and right. The Bluetooth antenna is on the right side of the headphones
so for optimal connectivity keep your Bluetooth enabled device on your right hand side
so that the Bluetooth signal does not have to pass through your body. Your body is
approximately 60% water and water blocks low power radio signals such as Bluetooth.
1. Ensure the headphones are
switched off
2. Press and hold the multi-function
button for approximately 4
seconds until the LED flashes
blue and red alternately
3. Search for the X-TOUCH on your
Bluetooth enabled device and
pair accordingly