SONIQ FMFTSSBR, User Manual

Page: 3 / 5

GETTING STARTED
Connect the unit with the external Speakers first, then plug the Adaptor to the DC IN Jack,
and finally plug the Adaptor in to a power outlet.
PHOTO MODE
1. Turn on the Power Switch. Switch to PH mode. The LED indicator will light up red.
2. Place Vinyl Record on Turntable and select appropriate speed (33/ 45/ 78) according to
the Record. NOTE: when playing a 45RPM record, use the supplied 45RPM Adaptor to
support the Record.
3. Remove the Stylus Protector. Open the Tone-Arm Clip to release the Tone-Arm. Push
the Lift Lever backward to raise the Tone-Arm and gently move the Tone-Arm to the
desired position over the Record. The Turntable will begin to spin when the Arm is
moved toward the Record. Push the Lift Lever forward to lower the Tone-Arm slowly
onto the Record to play it.
4. If the AUTO STOP Switch is turned on, the Turntable will stop automatically when it
comes to the end of the Record. If AUTO STOP Switch is turned off, the Turntable will
NOT stop automatically when finished.
5. Turn the Volume Knob to adjust the volume.
To replace Stylus, please refer to the following instructions:
To remove Stylus from Cartridge
1. Hold and pull down the Stylus as shown in direction “A”.
2. Remove the Stylus by pulling the Stylus forward.
To install the Stylus
1. Insert a Stylus by pressing as shown in direction “B”.
2. Push the Stylus upward as in direction "C" until the Stylus locks into position.
REPLACE STYLUS
2
Guide Pins(inside)