13
Dante Controller
3
13
Dante Controller
3
Another warning message will be shown asking you to confirm the reboot
procedure.
Fig 3-19: Reboot Warning Message
Again, click ‘Yes’ if you would like to con�nue. The device will reboot and
upon re-entering the ‘AES67 Config’ tab you will see that AES67 mode is
now enabled. Also note that the prefix address used for mul�cast is set to
‘69’ by default.
To route audio from an AES67 device to a Dante device with AES67 mode
enabled, first ensure that the mul�cast address of the source AoIP stream
has the same prefix as the device you would like to route it to. By default
the prefix is ‘69’ so the mul�cast address of the AoIP stream should be
239.69.X.X where the value of X can be any number between 0 and 255.
The you should make sure the address is not used more than once
otherwise AoIP streams will clash.
Fig 3-20: AES67 Stream Rou�ng
In the example an AES67 stream ‘AVN-PA8-0’ on the mul�cast address
‘239.69.2.38’ is routed to channels ‘01’ and ‘02’ on the device ‘AVN-AIO4-
Example’.
To create AES67 transmit streams first open the device configura�on
window, and click on the ‘Create Mul�cast’ flow icon. Alterna�vely hold
‘Ctrl’ and press ‘M’, the ‘Create Mul�cast Flow’ window will then open.
Fig 3-21: New Mul�cast Flow Icon
