Volume –
To adjust the volume rotate the
Volume wheel (12)
until you have reach the desired level.
Tone –
Adjust the tone by rotating the
Tone wheel (2)
until you have reach the desired level.
Dimmer Operation
There is a 5-level brightness control for the LED display. Press the SNOOZE button (8)
once to change the display brightness. The brightness will cycle from 5-4-3-2-1-2-3-4-
5 (from bright to dim then from dim to bright).
*NOTE*
:
The dimmer function will not work, when the clock is in snooze mode.
Bed Shaker / Vibrator – Figure B
1) Attach the bed shaker jack to the back of the clock at
VIBRATOR input (13).
2) To select vibrator, slide
Function Switch (11)
to VIB or VIB / BUZZ position.
3) Place vibrator under mattress or pillow.
USB Charging
This alarm clock is equipped with a convenient USB charging port on the back panel that
allows you to recharge many brands of mobile phones, portable music players, and other
handheld devices that are supplied with USB charging cables.
The output rating of the USB charging port is 500mA.
To charge your device, connect the USB charging cable that was supplied with your
handled device to the USB charging port (15) on the back panel of this alarm clock.
Observe the charging indicator on your device to confirm that it is charging.
Note: Charging time will vary depending on the charging current that your device requires.
Therefore some devices will take longer to charge than others.
Battery Backup –
To use the battery backup, you can install 2 pieces of AA size (UM-03) alkaline battery in
the back of the clock located under the battery cover (14). Please note the LED display
will not show during power failure but the clock will still be running and keeping proper
time until the power is restored.
NOTE:
For the best results it is recommended that the battery be changed every 6-8
months. If the clock is not used for a while, it is recommended to remove the battery to
aviod leakage.
DC 5V Power Input –
Attach the DC power supply input to the back of clock labeled DC5V
IN (1 ).
Important
:
do not confuse DC input with vibrator input.
