Songmics VASAGLE LHS10 Instructions Manual Download Page 2

Page: 2 / 15

General Guidelines

Please read the following instruction carefully and use the product accordingly.

Please keep this manual and hand it over when you transfer the product.

This summary may not include every detail of all variations and considered steps. Please contact us when
further information and help are needed.

Warnings

Notes

It is not intended for use by children under 3 years of age. Children must be under adult supervision to use the
product.

It is forbidden children to climb or play on the product to avoid serious body injury caused by the tilt.

Please don’t use this item as the ladder.

During the assembly process, keep small parts out of the reach of children. It may be fatal if swallowed or
inhaled.

To avoid potential danger of suffocation, keep all parts and packaging (films, plastic bags and foam, etc.) away
from babies and children.

The item is only intended to be used indoors. The uses that do not match the above description or unauthorized
change and modification are not permitted. Otherwise it may result in the personal injury or the breakage of the
product. The product must be strictly assembled and used in accordance with the provisions of the manual. The
seller does not assume any responsibility or liability with respect to any damage caused by incorrect assembly
or improper use.

It is recommended to mount the article by 2 adults and prepare an electric drill to facilitate the assembly. Please
strictly adhere to the assembly steps.

If there is defective or missing part after unpacking, please contact us immediately and stop the assembly.

Please assemble the item in spacious room and do not place the unwrapped product directly on the ground to
avoid damage. It is recommended to wear gloves in the assembly to avoid scratch by the sharp edges.

It is not allowed to stand, sit or put heavy stuff on the wooden boards or other parts before the assembly to
avoid the crack or distortion of the wooden boards. The crack or distortion will affect the assembly and normal
use.

Please match the corresponding board and fitting based on the part number in the manual. If the board does not
match with the fitting, please check the pieces as specified in this manual.

Please refer to the diagram during assembly. Allign all the screws with the related pre – drilled holes first and
later tighten the screws one by one after putting all the screws in the correct places.

Please note that each type of screws has a spare screw.

Inspect the screws to make sure the firmness of the connection points during use. If necessary, tighten them
again.

Protect the article from sunlight exposure or rain, and do not put it in a humid place. It may accelerate the
distortion, discoloration or fissure. Never touch with sharp objects or corrosive chemicals, which may spoil the
surface of the item.

For daily care, please clean with a damp cloth firstly and wipe with a dry cloth.