Instructions for installation of bluetooth
Safety during installation
The installation must be performed by a person properly qualified in electrical engineering. Before commencing
the installation, always disconnect mains voltage.
During installation of the bluetooth, the following conditions must be observed:
•
The bluetooth mounting box must be placed flush with the plaster.
•
In case of problems with a “sunk” mounting box, the VK1 or VK2
spacer (distance) rings must be used in order to prevent deformation of the
fittings when the screws are tightened.
•
The switch is fastened in the mounting box though a sheet-metal
frame by means of two screws of 3 mm diameter (Fig.1,2).
•
Position the frame correctly, see Fig. 2, lugs marked with arrows
•
To install multiple fitting assemblies, it is necessary to use multiple
boxes with the spacing of centres of 71 mm.
•
It is recommended to place the bluetooth in the mounting boxes at
the approximate depth of 40 mm.
•
Plastic base segment, pos. 3, snap on the sheet metal frame
•
In the bluetooth switch, pos. 4, strip insulation and connect the
wires according to the wiring diagram. Then insert the bluetooth unit in the
base segment, pos. 3, together with the sheet metal frame, pos. 2, until the
bluetooth is locked with the lugs positioned on the sides.
•
Put the frame, pos. 5 (wood, metal, plastic, etc.) on the base segment, pos. 3
•
Finally, fit the visible component - intermediate frame, pos. 6
Disassembly of bluetooth
•
Use a flat screwdriver and slide the intermediate frame out carefully
•
Then remove the frame
•
Finally, remove the complete bluetooth device using the screwdriver.
The product contains no hazardous substances; after expiration of its service life, it must be handled in
conformity with the waste act in force or pertinent related regulations.
