Sonel P-3, Operation Manual

Page: 12 / 20

10
If both devices were mated before go on to
point 2.8.2.2.
2.8.2.1 Mating
1. Connect the LKN-710P transmitter cables to the
source of alternating voltage 24...230V. After the
connection has been performed, the red diode
should blink signalling its operation in the conduc-
tor tracking mode (along with the LKO-710 re-
ceived by SONEL S.A.).
2. Then, press the button twice, until the di-
ode turns greed (continuous light).
3. Press fleetingly the L123 button on the P-3 dis-
play. The following message should be displayed
and after a short while the symbol .
4. Then hold the L123 button until the message
is displayed
.
5. Keep the button of the LKN-710P transmit-
ter until the green diode stops blinking.
6. Now the transmitter is synchronized with the P-3
indicator. The process of synchronization lasts up
to 30 seconds. The symbol may blink during
synchronization.
7. Correct mating of the transmitter with the indica-
tor is signalled as follows:
•
The message is replaced by ,
while the symbol is displayed con-
tinuously,
•
The green diode of the transmitter blinks
faster than at the moment of mating,
signalling transmission of phasing sig-
nal.
From that moment on both devices are ready
for work in tandem.
Note :
Green light signal indicated operation of the
transmitter in the P-3 mode.