™
If contact numbers have not been set in the device previously, it
automatically enters the number setting mode when you switch the device
on. If you want to change previously set numbers, you can enter the
number setting mode when you are switching on the device. When the
device is starting up, the yellow indicator light blinks. When the blinking
ends, the green light turns on for two seconds. When the green light is on,
press the function button once and the device enters the number setting
mode.
The green and yellow indicator light blink in turn when the device is in the
number setting mode. When the device receives an SMS message in the
correct format, the yellow indicator light turns on for a moment and the
device saves the phone numbers to the memory slots that were reserved
for them. When the phone numbers have been saved, the indicator lights
blink in turn again, which indicates that the device is in the number setting
mode. To enter the standby mode, briefly press the function button once.
If the device receives an SMS message that is not in the correct format
described above or some other error occurs, the device indicates an
incorrect message with a sound signal and the red indicator light turns on.
Then the device returns to the number setting mode.
To exit the number setting mode, press the function button once. The
device enters the standby mode. If the phone numbers have not been set
in the device yet, it gives a sound signal and the red indicator light turns
on to indicate an error. The device remains in the number setting mode. If
you do not want to set the numbers in the device, you can switch it off
(see chapter
Switching off the device
). In case of an emergency you
can make an emergency call (see chapter
Emergency calls
) or receive
phone calls. After ending the call the device returns to the number setting
mode.
NOTE! The charging indicator lights do not burn when the device is in the
number setting mode, but normal charging proceeds even while the device
is in this mode.
Phone calls:
When Soneco
SCS
is in the standby mode you can make phone call to
pre-programmed number and receive incoming calls. Except for
emergency call, you can make phone call only when the device is within
the coverage area of your own operator’s GSM network. The green
indicator light blinks every two seconds to indicate standby mode.
Making a call:
Press the function button briefly in the standby mode. The device sends
SMS message and then makes the phone call to the same number. In a
meanwhile it sends the SMS to the second pre-programmed number. If
the device is unable to complete the call, it returns to the standby mode.
8
Summary of Contents for SCS
Page 1: ... Soneco SCS User Guide 1 ...
