Somogyi home FKIR 452, Instruction Manual, Page: 6 / 40

6
43. Do not insert an accumulator instead of the battery, because it provides significantly lower
voltage and efficiency.
44. Do not weld or solder directly to the battery.
45. Store unused batteries in their original packaging, away from metal objects. Do not mix
batteries which have already been unpacked.
46. The unit is intended for household use. No industrial use is permitted.
47. Due to continuous improvements, the technical data and design may change without any
prior notice.
48. Due to continuous improvements, the technical data and design may change without any
prior notice.
49. The actual instruction manual can be downloaded from www.somogyi.hu website.
50. We don’t take the responsibility for printing errors which may occur, and apologize for
them.
CAUTION: RISK OF ELECTRIC SHOCK!
Do not attempt to disassemble or modify the unit or its accessories. In case any part is
damaged, immediately power off the unit and seek the assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by
the manufacturer, its service facility or similarly qualified personnel.
DO NOT COVER! COVERING THE UNIT CAN CAUSE OVERHEATING, FIRE
OR ELECTRIC SHOCK.
THE REMOTE CONTROLL IS NOT A TOY. KEEP OUT OF REACH OF CHILDREN.
COMMISSIONING
1. Before installation, carefully remove packaging, and make sure not to damage the unit or
the power cord. If you find any damage, the unit must not be operated!
2. Take out the unit from the box.
3. To ensure proper operation, you have to arrange for the free circulation of hot air. Therefore,
please, observe the minimum clearances indicated in Figure 3.
4. Use the drill guide provided to make the holes in the wall for the dowels provided or the
ones you want to use.
5. Insert the dowels into the holes, then the screws provided or the ones you want to use into
the dowels so that the screw heads protrude app. 10 mm from the wall surface.
6. Align the holes on the back of the device with the screws, then slide the device to the left
and down. Make sure that the heater is fixed firmly on the wall or ceiling.
7. Make sure that the main switch of the device is in the off position.
8. Plug the unit into a standard grounded wall socket. Now the unit is ready for operation!