WTT animeo IB+/IB • REF. 5057571C -
2/4
WTT animeo IB+/IB • REF. 5057571C -
3/4
C. Detectable errors
Error 1: Motor Controller without supply
Error 2: Missing IB+ transmission to the Motor Controller
Error 3: Short circuit in the IB+ bus, between the C and IB+ wire (a short circuit
is indicated by 4 simultaneously flashing LEDs on the wiring test tool)
Error 4: Inverted up/down motor connection
Error 5: Broken fuse for the corresponding motor output
Error 6: Broken motor or missing connections
Error 7: Inverted up/down wires or short circuit on the IB bus. Start to look for the error from the
Motor Controller which is closest to the Building Controller
Error 8: Wiring mistake on the local switches
Remark: When running long test sequences the thermal protection of the mo-
tors could be activated. In this case wait 30 minutes before continuing.
D. Wiring test sequence
1. Testmode on
by pressing
(1 sec) the button on the back
of the tool.
Testmode on = orange LED blinks
3 x. Running light on all connected
Motor Control lers. During the
test mode, all local switches are
disabled!
Error 1
Error 2
Error 3
After correc-
tion,
repeat this
step until the
running light is
enabled on all
Motor Control-
lers
4. Test mode off
by pressing
(1 sec) the button on the back of
the tool.
Test mode off = yellow LED blinks 3 x. The running light on the
Motor Controller stops. All local switches are enabled again!
2a. IB+ Down order.
Order
indicated on WTT by blinking of
the red and the green LED.
Visual check of all blinds in the zone.
All blinds move down for approx.
10 sec.
Wrong running
direction
Error 4
Does not move
Error 5
Error 6
After correction,
repeat step 2a
and 2b until
o.k.
2b. IB+ Up order.
Order indi-
cated on WTT by blinking of the
red and the green LED.
Visual check of all blinds in the zone.
All blinds move up for approx. 10 sec.
3a. Switching to IB mode
in order to test the C, up and down (
st
) wires of the IB bus.
(You may switch from IB to IB+ by pushing the mode button for 3 sec)
3b. IB Down order.
Order
indicated on WTT by blin king of
the red and the yellow LED.
Visual check of all blinds in the zone.
All blinds move down to the lower
end limit.
Error 7
After correction,
repeat step 3b
and 3c until o.k.
3c. IB Up order.
Order indi cated
on WTT by blinking of the red
and the orange LED.
Visual check of all blinds in the zone.
All blinds move up to the upper end
limit.
WTT Command
Reaction
Possible error
WTT order
Reaction
Possible error
5.
Check each of the local switches in the building individually!
Error 8
