Note
If shade is actively moving (in-motion)
Should be pressed twice.
To Delete: Activate shade to intermediate
position, then press and hold (stop)
for 5 seconds. Shade will jog to confirm
deletion.
Press both and at the same time until the motor jogs
Adjust to a new lower limit position. Press until the motor jogs
Press both and at the same time until the motor jogs.
Adjust to a new upper limit position. Press until the motor jogs
STEP 6: Confirm limit settings
Press and hold (stop) until
the motor jogs to confirm the
limit settings.
STEP 5: Set the limits
Press both
(stop) and
at the same time
until the
motor moves, then release.
The motor will stop at the
original upper limit.
STEP 2: Initiate programming
Press both and
at the
same time
until the motor
jogs.
In programming mode the
motor operates in momentary
fashion.
STEP 1: Connect power
With the motor installed in shade
connect power to the motor
(120V, or 12 V or 24V transformer
or 12 V battery wand)
Before you begin
Motors are shipped without limit settings and transmitter ID’s.
Steps 1 to 7 must be completed to ensure proper shade programming and functionality.
It is recommended to power only the motor being programmed (disconnect power to all the other motors)
Motor will exit programming mode after 2 minutes of inactivity.
STEP 4: Set the limits
Bring the motor to desired
upper
limit. Press both
(stop) and until the
motor moves, then release.
(If
the motor stops when the buttons are
released take it back to the upper limit
and repeat)
Stop the motor when
reaching the desired
lower
limit. You can adjust by
pressing or
STEP 3: Check directions
Press or
When pressing product
should go down or out.
To change direction press and
hold (stop) until the
motor jogs
(shade has a short up and
down movement)
STEP 7: Set user mode
Press and hold the
programming button on the
back of the transmitter until
the motor jogs. It will now
operate in a maintained
fashion (user mode).
Double check limit settings as
a precaution.
To change the lower limit
Send the motor to it’s current lower limit.
To change the upper limit
Send the motor to it’s current upper limit.
QUICK PROGRAMMING GUIDE FOR ALL RTS MOTORS
TM
WIREFREE ROLL UP LT-30RT Round Head and CORD LIFT CT-32 MOTORS
Please refer to individual instructions for more details
Programming Mode
Adjusting the limits in User Mode
Setting
Send the shade and stop it at
the desired intermediate
position by pressing (stop)
Once the desired Intermediate
position is reached, Press and
hold (stop) until the shade
jogs. The Intermediate position
is now added to memory
Using
Send the shade to the
intermediate position by
pressing (stop) from ANY
shade position..
Note: Shade should be
stationary prior to activating
intermediate position
function.
Setting an Intermediate Position
A jog is a brief up and down motion
A jog is a brief up and down motion
