SOMFY Sunea Screen 40 io, Instructions Manual, Page: 29 / 104

29
EN
Copyright © 2016 Somfy SAS. All rights reserved.
Images not contractually binding
2.4. TIPS AND RECOMMENDATIONS FOR INSTALLATION
2.4.1. Questions about the Sunea Screen?
Observations Possible causes Solutions
The motorised product does
not operate.
The wiring is incorrect. Check the wiring and modify it if necessary.
The overheating protection on the drive has
been activated.
Wait until the motor cools down.
The control point battery is low.
Check whether the battery is low and replace it if
necessary.
The control point is not compatible.
Check for compatibility and replace the control point if
necessary.
The control point used has not been
programmed into the motor.
Use a programmed control point or program this control
point.
The motorised product
stops too soon.
The crown is incorrectly positioned. Fit the crown correctly.
The end limits have been incorrectly set. Readjust the end limits.
2.4.2. Replacing a lost or broken Somfy control point
Only switch off the power to the application to be reset.
This reset deletes all the local control points, however the sensors, end limit settings and favourite position are retained.
1)
Position the motorised product at the mid-height position.
2)
Cut the power supply for 2 seconds.
3)
Switch the power supply back on for 5 to 15 seconds.
4)
Cut the power supply for 2 seconds.
5)
Switch the power supply back on: the motorised product moves for a few
seconds. (If the application is in the upper or lower limit position, it will make a
brief up and down movement).
6)
Press the PROG button on the new control point until the motorised product
moves up and down: the new control point is programmed and all the other control
points are deleted.
1
4
2 sec.
OFF
5
ON
2
2 sec.
OFF
3
10 sec.
ON
PROG.
6
1