Copying Programmed Channel onto 5th Channel
You can copy the programming of channels 1 - 4 to channel 5 to operate all the blinds simultaneously.
1. Press the SELECTION button to select the channel to be copied.
2. Press and hold the PROGRAMME button on the back of the handset (using a screwdriver or
paperclip) until the blind jogs (moves up and down briefly).
3. Press the SELECTION button to select channel 5 (when all four indicator lights are on).
4. Briefly press the PROGRAMME button on the back of the handset. The blind will jog. Your
programming has been recorded.
5. Repeat steps 1- 4 to copy any further channels.
Programming the Intermediate ‘My’ Position
The My position allows you to set the blind at your favourite position.
1. Press the UP and DOWN buttons to move the blind to the desired position.
2. Press and hold the MY button for approximately 5 seconds until the blind jogs. Your ‘My’ position
has been recorded.
Deleting the ‘My’ Position
1. Press the MY button to move the blind to the programmed ‘My’ position.
2. Press and hold the MY button for approximately 5 seconds until the blind jogs. Your ‘My’ position
has been deleted.
Adjusting the Up and Down Limits
1. Leave the blind at its current upper limit position if you want to adjust the upper limit position, or its
current lower limit position if you want to adjust the lower limit position.
2. Press the UP and DOWN buttons simultaneously for approximately 5 seconds until the blind jogs.
3. Use the UP and DOWN buttons to adjust the blind to the new desired position.
4. To confirm the new position, press and hold the MY
button for approximately 2 seconds until the
blind jogs. Your new position limit has been recorded.
Factory Reset
If you want to erase all programming, you can perform a factory reset. Move the blind to the middle of
the window. Only switch off the current for the motor to be reset.
1. Cut the power supply for 2 seconds, then turn it back on and leave it on for 10-15 seconds.
2. Cut the power supply again for 2 seconds, then turn it back on again. The blind will move/jog for 5
seconds.
3. Press and hold the PROGRAMME button on the back of the handset until the blind jogs twice. All
programming will be reset to factory mode.
If you have any questions about programming, please call us.
