Motor side
Battery Tube:
Located near the
top of the window
frame and near the
motor side. May be
hidden from view.
Panel:
Located near
the top of the
window frame and
near the motor
side. When fully
open, shade or
fascia may help
conceal panel
from inside view.
Installed:
When fully open,
shade or fascia
may help conceal
Solar Pack from
inside view. Wire
Harness is tucked
away.
Upper Liner
Master Liner
Adhesive must stay with upper liner
when peeled away from master liner
Figure 1.
Glass Mount Adhesive
Figure 2.
Apply to all 4 corners
Adhesive
3. INSTAllATIoN
3.1 determine location of Solar Panel
The solar panel must always be installed indoors, directly against the
window glass so as to allow as much natural light as possible to reach the
panel.
Caution!
Never install the solar panel on any window glass allowing
less than 65% light transmission (including Low E glass and/or
window tinting), or obstructed by a window pane or bug screen.
Always leave the photovoltaic cells unobstructed, do not put anything in
front of them.
The three components which make up the Solar Pack must be installed on
the same side as the WireFree™ motor.
Somfy recommends that all components be fitted systematically in order
that all components may be connected to the wire harness easily, and that
the wire harness does not interfere with the free movement of the interior
window covering.
Please Refer to the Solar Pack Performance Tables Section 8.0 to confirm
proper usage per blind and window orientation.
3.2 Mounting the Solar Panel.
Caution!
It is imperative that window hardware or framing
does not collide with the solar panel!
Careful! Do not damage the wire harness cables during installation.
Determined the position of the solar panel (against window, within
reach of wire harness) prior to application of 2-sided tape to insure
proper adhesion the first time.
3.2.1 Glass Mounting
Caution!
To insure a secure adhesive hold over a long
period, prepare the inside window glass prior to mounting
the solar panel.
Important!
The adhesive tape should never be touched directly
with fingers (or other contaminates) prior to adhesion.
1) Clean solar panel bezel corners and window area with alcohol
prep pad. Let dry for two minutes.
2) On a table, with the solar panel facing up, apply the 2-sided
adhesive to four corners of the solar panel bezel.
Note:
The tape is precut for your convenience in between the top
(facer) and bottom (backer) liners. With your fingers, lift off each
precut adhesive piece so that it remains attached to the “facer”
material and the opposite side of the tape should then be released
from the back liner. See Photo in Figure 1 and Figure 2.
3) Remove the “facers” of the applied adhesive.
Position the bezel with solar panel facing to outdoors , then press
entire panel with firm, even pressure into the glass for 10- 15
seconds. The panel is now supported by the adhesive to glass
bond but will require 24 hours of cure time to allow full strength
characteristics. Do not disturb during this period.
