SOMFY Oximo WT, Instructions Manual

Page: 47 / 120

45 Copyright © 2005 - 2014 Somfy SAS. All rights reserved. Non contractual images
EN
2. 3. 2. 4. YJX‚
š ; ”$Z{
; _ ;
end limits must be set using the control point.
Setting the upper end limit
1)
J œkœ œ„;œ $
$Z#
2)
J œkœ $
$Z#
3)
Place the roller shutter in the desired upper end
limit position.
@
{# #
) œkœœ„;œ$
4)
ž” œ„;œ $
) $Z#
Setting the lower end limit
5)
Place the roller shutter in the desired lower end
limit position.
@
{# #
) œkœœ„;œ$
6)
ž” œkœ$ )
$Z#
7)
J œkœ œ„;œ $
$Z#
~
The lower end limit position is programmed.
2. 4. TIPS AND ADVICE ON INSTALLATION
2. 4. 1. ŽXY^€
Problems Possible causes Solutions
The roller
shutter rotates
in the wrong
direction. The wiring is incorrect. €Z ;)#,
The roller
shutter does not
operate. The wiring is incorrect. €Z ;)#,
The overheating protection on
the drive has been activated. Wait for the drive to cool down.
The control point is not
compatible. €Z $
control point as required.
The roller
shutter stops
too soon. The roller shutter is encountering
# ; G$$)
)
interference between the winding
$ €Z #
$$)
{# $
))
The drive has been installed in a
new roller shutter. Restore the drive to its original
)
œ‚ ) )) œ
The roller
shutter does
not stop at the
lower end limit. 8) $ €Z
;) $; )Z
The roller
shutter does
not stop at the
upper end limit. The system for stopping the
roller shutter in the upper
position is unsuitable. €Z ;
;
removable stops incorporated into the
guide rails or an end slat that acts as a
stop.
H
{
5)
3s
1)
7)
3)
3s
0.5s
0.5s
3s
3s
3s
4)
6)
2)