Copyright © 2009 Somfy SAS. All rights reserved.
Oximo WireFree™ Solar Panel
16
EN
6) Remove the protective paper from the adhesive on the
back of the right-hand solar panel.
Press the solar panel frame uniformly against the casing
7)
to mount the right-hand solar panel.
Caution! Never press on the photovoltaic cells: they could
break.
Slide the wire from the right-hand solar panel inside the
8)
groove on the back of the left-hand solar panel.
Feed through the solar panel wires inside the casing via
9)
the drilled hole (F).
Protect the wires from the hole edges by positioning the
10)
protective foam pads at that point.
Remove the protective paper from the adhesive on the
11)
back of the left-hand solar panel.
Press the solar panel frame uniformly against the casing
12)
to mount the left-hand solar panel.
Caution! Never press on the photovoltaic cells: they could
break.
Remove the protective films from the photovoltaic cells.
13)
4. Wiring
Caution! The cables and connectors must be protected from
the roller shutter movement.
Somfy recommends placing the connectors behind the end
piece and fixing the cables inside the roller shutter casing.
4.1 Scenario with 1 solar panel
Wire the solar panel 2-pin connector to the battery
1)
connector (G).
Wire the Oximo 40 DC RTS motor 4-pin connector to the
2)
battery connector (H).
See the Oximo 40 WireFree™ RTS guide.
4.2 Scenario with 2 solar panels
Wire each solar panel to a Y cable connector (I) (Oximo
1)
Wirefree™ Y Cable, not supplied).
Wire the Y cable 2-pin connector (J) to the battery
2)
connector (G).
Wire the Oximo 40 DC RTS motor 4-pin connector to the
3)
battery connector (H).
See the Oximo 40 WireFree™ RTS guide.
6-7
13
11-12
8
10
9
F
H
G
1
2
1
2
H
3
J
G
I
