WIND Function
DEMO Mode
TIME DELAYS
The
is able to control and provide a measure of protection
for retractable awnings according to wind conditions.
The WIND threshold can be adjusted by a potentiometer to detect wind speed
between 6 - 31 miles per hour.
EOLIS RTS sensor
When the wind
speed exceeds
the threshold
set by the
EOLIS RTS
, an UP
order is given
to the awning after 2 seconds
sensor
The mode is selected by turning the wind
potentiometer clockwise to the limit.
The change of setting "In" or "Out" of the Demo Mode
is confirmed with a brief Jog of the motor. This function
can be used to confirm the sensor is communicating
with the motor's receiver.
In this mode all time delays are reduced to
facilitate installation. The wind threshold is 6 mph.
This is the elapsed time required for the motor to respond
automatically or manually (using the transmitter) to the
change in wind conditions.
WIND appearing timing
WIND disappearing timing*
Normal mode
2 sec.
12 min.
Demo mode
2 sec.
15 sec.
As long as the
measured
wind speed is
higher than the
adjusted threshold, all commands
are prevented from operating.
(manual control or automatic control).
When the wind
speed falls
below the
threshold setting,
an order can be
given with the RTS
transmitter after 30 sec.
-
Demo
after
30 sec.
after 2 sec.
+
A. To Enter the "programming mode"
C. To delete all the sensors and record a new one
The motor must be in
to record an
Up to three
can be memorized in
one motor. One
be memorized into
several motors.
programming mode
EOLIS RTS
EOLIS RTS
EOLIS RTS
sensor.
sensors
sensor
n
ca
Activate the receiver's memory
by pushing (for more than 2
seconds) the
on a transmitter already
recorded in the motor's memory.
programming
button
The awning jogs briefly
DOWN/UP. This confirms
the motor is in
programming mode.
Press
on the
"programming"
button of the
EOLIS RTS
briefly
sensor
Press for
on the "prog"
button of the new
EOLIS RTS
.
more than
7 sec.
sensor
The awning jogs briefly (DOWN/UP).
If it is a new sensor :
If the sensor was previously recorded :
it will be
in the motor.
it will be
recorded
deleted.
The awning jogs briefly (DOWN/UP).
The receiver is cleared (all previous
sensors are erased) and the new
sensor is recorded.
-
+
B. To Record or delete a sensor
-
+
-
+
> 2 sec.
Operation
4
Programming
3
-
Demo
+
NOTE: Do not leave RTS sensor in demo mode when
installation is completed.
* It is possible after 30 sec. to give a
down order with the RTS transmitter
