7.
If the shade has stopped where you want it, press and hold
the “my” button till the shade jogs; then flip the remote over
and press the programming button on the back of the remote
and the shade will jog.
8.
You have just completed programming your shade.
NOTE: If you are using a decoflex wall switch, substitute the
“stop” button for the “my” button. The programming button
is a paperclip size hole next to the down arrow
.
Resetting to factory default
1.
On the end of the motor, near the battery connection, there is
a small hole about the size of a paper clip.
2.
Put a paper clip into the hole and gently apply constant
pressure.
3.
Continue to apply pressure until the shade jogs 3 times.(If
you lose your grip and release before the 3 jogs, you will
have to start over).
4.
After the 3 jogs, the shade is now reset to factory default.
Adding a “All” Channel
1.
Start with the channel the shade works with.
2.
Press the programming button on the back of the remote or
front of wall switch – the shade will jog.
3.
Select the “all” channel, then press the button on the back of
the remote or front of wall switch – the shade will jog.
4.
Now the shade will work on both channels.
