5
4
Disassemble current roller blind and remove the fabric.
Slide the motor into the tube and the idle end (I) onto the
opposite end of the tube.
.
Measure the width of your existing roller blind tube, mark
the new aluminium tube to this width and saw vertically to
length using the cutting guide. Start sawing on the tape.
Peel the backing off the double-sided tape and fix the
fabric to it. Make sure the fabric lies flat on the tube
without creases. To help mount the fabric straight and
wrinkle free, peel the backing tape off in steps.
Fit the crown wheel (C), drive wheel (D) and drive plate (P)
to the motor.
STEP 1
STEP 4
STEP 2
STEP 5
Continue to
steps 6-9
STEP 3
C
D
P
I
!
!
INSTALLATION OF THE ROLLER
BLIND DIY AUTOMATION KIT
