OPERATING INSTRUCTIONS
PROGRAMMING PROCEDURES
System Set Up
Operating Procedures
TRANSMITTER
1. With power off, wire Centralis as indicated above. Turn all circuit
breakers on (motors should not move).
1. Pressing the UP button on the Telis transmitter will move the window
treatment up or in. The DOWN button will move the treatment down or
2. Set the Centralis Receiver into programming mode by pressing the
out.
programming button on the receiver until the LED lights (about 5
2.
To stop the motorized treatment at any time, press the CENTER button
seconds).
on the transmitter.
3. To reach one of the intermediate positions, the awning or rolling shutter
3. Press the programming button on the Telis1 or Telis4 transmitter. Make
must first be at the upper or lower limit, and stopped. Pressing the
sure the desired channel is selected on the Telis4 before programming.
center button on the transmitter will move the window treatment to the
The programming LED on the Centralis will blink indicating the
dedicated position.
transmitter has been memorized.
LOW VOLTAGE SWITCH
4. Operate each motor in the DOWN direction using the radio transmitter.
4.
If desired, a single pole, single throw switch can be connected to the
low voltage terminals as indicated above. Each press of the switch will
5. The motorized treatment should move down or out. If this is incorrect,
sequence through the directions as follows;
turn off the circuit breakers and reverse the red and black wires of the
DEPRESS 1 UP DIRECTION
motor.
DEPRESS 2 STOP
DEPRESS 3 DOWN DIRECTION
DEPRESS 4 STOP
RECORDING THE INTERMEDIATE POSITION FROM THE TOP OF THE WINDOW TREATMENT
- Bring the window treatment to its upper limit using the Telis transmitter. Press the DOWN and CENTER buttons simultaneously until the awning begins to move,
then release.
- Stop the window treatment at the intermediate position desired. Press the CENTER button for 2 seconds to memorize that position.
RECORDING THE INTERMEDIATE POSITION FROM THE BOTTOM OF THE WINDOW TREATMENT
- Bring the motorized treatment to its lower limit. Press the UP and CENTER buttons simultaneously until the awning begins to move, then release.
- Stop the window treatment at the position desired. Press the CENTER button for 2 seconds to memorize that position.
DELETING AN INTERMEDIATE POSITION
- Briefly press the CENTER button of the Telis transmitter to reach the desired intermediate position.
- Continue to press the CENTER button for 10 seconds until the programming LED on the Centralis Receiver stops blinking. That position is now deleted.
TO ADD A NEW TRANSMITTER TO THE MEMORY OF THE RECEIVER
- Press the programming button, for more than 2 seconds, on a transmitter that is already memorized by the Centralis Receiver to wake up the receiver. The
programming LED on the Centralis will light. Press the programming button on the new transmitter to attach it to the Centralis Receiver.
TO REMOVE A TRANSMITTER FROM THE MEMORY OF THE RECEIVER
- Press the programming button on the Centralis Receiver until the LED lights. Quickly press the programming button on the transmitter you want to remove.
TO REMOVE ALL TRANSMITTERS FROM THE MEMORY OF THE RECEIVER (Resetting of the Centralis Receiver)
- Press the programming button of the Centralis Receiver until the LED blinks. This removes ALL memorized transmitters.
WIRING DIAGRAM
MOTOR
R
HOT
NEUTRAL
GROUND
BLACK
RED
GREEN
WHITE
COLOR CODE
Programming Button & LED
To Optional
Low Voltage Switch
NOTE:
Mount control with
fittings facing downward!
Programming
Button
Telis Transmitter
UP
DOWN
MTR COM
NEUT
HOT
