animeo IB+
4 Zone/8 Zone TouchBuco BACnet
2020/04/30
Seite 39
Send to selected zone
Once the setup is completed, the data must be sent to the motor controllers, either to all motor controllers of
a zone or just to specific motor controllers. With animeo IB+ 2-, 4-, 6- unit motor controllers, you can even
send the data to certain motor controller outputs (1 to 6).
Hit "Start" to send the data entered to the selected zone.
You can use "
Send over ID
" function to send the data entered directly to the device/outputs via the ID
address of the motor controller.
Example of use: If shorter motorized products are installed within a zone, you can also set shorter runtimes
for these motor controllers. We generally advise against different turning times and a different mechanical
tolerance within a zone setting. If you encounter slight deviations between various motorized products/end
products due to the mechanical systems used, you should try to find a compromise.
This function is, for example, also useful when you have replaced a motor controller. However, do not forget
to make a zone assignment for the corresponding motor controller.
Enter the ID address. You can find this on the barcode sticker on the motor controller (example
"ID:8390363". With the Smoove UNO IB+, the address is printed on the rear of the front panel.
If desired, determine the motor controller outputs/drives that are to receive this data. Then hit "Send".
6.5.2.4 Switch Config
With animeo IB+ 2-, 4-, 6-unit Motor Controllers, each Motor Controller output has a sensor input for local
operation. This means that you can change the assignment of the sensor inputs to the Motor Controller
outputs (see example). However, this only works with outputs on the same Motor Controller. This means that
the specialist does not need to connect wire jumpers to the sensor inputs.
Example:
1. animeo IB+ 4-unit Motor Controller with "1+1+1+1"setting (factory default setting)
Each button controls one Motor Controller output.
2. animeo IB+ 4-unit Motor Controllers with "2+2"setting
Sensor inputs 1 and 2 control Motor Controller outputs 1 and 2, while sensor inputs 3 and 4 control
Motor Controller outputs 3 and 4.
Setting:
Select the corresponding sensor input/Motor Controller output assignments.
You can either send the setting to all Motor Controllers within a zone (= "Send Zone") or just to specific
Motor Controllers via the ID address (= "Send ID"). The ID address is on the barcode sticker on the Motor
Controller. Hit "Send" to send off the settings.
Summary of Contents for animeo IB+ 4 Zone Touch Building Controller
Page 49: ......