animeo IB+
4 Zone/8 Zone TouchBuco BACnet
2020/04/30
Seite 16
6.1.2 Rain/Snow
This function is used to protect end products/shades from precipitation for safety reasons. In the event of a
rain/snow alarm, further operator commands (local operation via buttons, radio control, etc.) and low-priority
automatic commands are locked. The "IB" LED on the Motor Controller lights up red to indicate that com-
mands have been locked.
H
Snow can only be detected when an outdoor temperature sensor has been fitted and enabled. Without an
outdoor temperature sensor, all precipitation is simply classed as rain.
The rain function is activated if the precipitation lasts longer than the "Delay Time On" specified. If the out-
side temperature is less than 4° C, the system assumes that it is snowing. The behavior of the motorized
product in the event of rain and snow can be adjusted. The rain function is enabled again when no further
precipitation is measured following elapse of the "Delay Time Off".
You can navigate through the setting using the grey "forward" and "backward" arrows.
Enabling the function:
To enable the Rain/Snow function, you need to move the slider to the right.
Setting the Rain/Snow function:
Delay time:
Adjustment range "On" from 0 to 60 seconds. Adjustment range "Off" from 0 to 255 minutes.
Rain/Snow On:
Lock Only
The end products/shades in a zone stop moving and low-priority manual and automatic com-
mands are locked.
Up Priority
The end products/shades in a zone move to the upper end limit and low-priority manual and
automatic commands are locked.
Down Priority
The end products/shades in a zone move to the lower end limit and low-priority manual and
automatic commands are locked.
6.1.3 Frost/Ice
This function is used to protect end products/shades from frost (cold) or ice (precipi cold) for safety
reasons. In the event of a frost/ice alarm, further operator commands (local operation via buttons, radio con-
trol, etc.) and low-priority automatic commands are locked. The "IB" LED on the Motor Controller lights up
red to indicate that commands have been locked.
The frost and ice functions cannot be enabled at the same time (either frost or ice). Both functions are ena-
bled when the temperature exceeds the threshold set by + 2° C.
Frost
This function is activated if the outside temperature remains below the threshold for longer than the "Delay
Time On" specified. The behavior of the end products/shades in the event of frost can be adjusted. The func-
tion is released as soon as the "Delay Time Off" has elapsed. This starts counting as soon as the tempera-
ture exceeds the threshold set.
Ice
This function is activated if the outside temperature remains below the threshold for longer than the "Delay
Time On" specified and if precipitation has been registered during the period of the "Rain History" set. The
behavior of the end products/shades in the event of ice can be adjusted. The function is released as soon as
the "Delay Time Off" has elapsed. This starts counting as soon as the temperature rises 2° C above the
threshold set. The "Delay Time Off" can be set to a maximum of 3,000 minutes. This function can be manu-
ally reset.
You can navigate through the setting using the grey "forward" and "backward" arrows.
Summary of Contents for animeo IB+ 4 Zone Touch Building Controller
Page 49: ......