animeo IB+
4 Zone/8 Zone TouchBuco BACnet
2020/04/30
Seite 13
3.2 Control all
Standard all: Here, you can move the motorized products in all zones selected up and down using the
up/down arrows. The stop button allows you to stop the motorized products and the "my" button allows you
to move them to the intermediate position set (please refer to "Settings/Options").
Advanced all: In this section, you can enter the precise position value as a percentage for all zones selected.
In the case of Venetian blinds, you can specify the angle in degrees. With roller shutters and Venetian blinds,
0 % corresponds to the raised position, while with windows it means "closed". The set position for all zones
is approached using the "Go to Position" function.
Zone unlocked/locked: You can lock the zone entirely, for example to clean the windows, so that neither
local operation nor automatic control is possible. The zone can nevertheless be controlled using the
TouchBuco by means of safety commands.
Simply press the button again to release the function.
Sun enabled: You can use this button to switch the sun function on and off if the sun function is used for this
zone.
3.3 Control all settings
Control zones used:
Here you can select the zones to be controlled via "Control All".
4 Sensors
In this section, all sensors which are connected and in use are displayed as icons together with their current
measured values. The numbering from 1 to 8 indicates the number of the sensor type used.
Sensor errors are displayed by means of different symbols. This can be caused by various factors:
"-"
Unused sensor.
"C"
Sensor is selected in sensor menu but sensor is not available/connected.
" * "
Sensor is not selected in sensor menu but sensor is available/connected.
" S "
Sensor or wiring short-circuited.
" ! "
Communication to the sensor station impaired or interrupted (check connecting lines).
Please contact your specialist if you are not sure or require assistance.
4.1 Outside
In this section, all sensors which are connected and in use are displayed as icons together with their current
measured values. The numbering from 1 to 8 indicates the quantity and type of sun sensors used.
Sensor errors are displayed by means of different symbols. This can be caused by various factors:
"-"
Unused sensor.
"C"
Sensor is selected in sensor menu but sensor is not available/connected.
" * "
Sensor is not selected in sensor menu but sensor is available/connected.
" S "
Sensor or wiring short-circuited.
" ! "
Communication to the sensor station impaired or interrupted (check connecting lines).
Please contact your specialist if you are not sure or require assistance.
Summary of Contents for animeo IB+ 4 Zone Touch Building Controller
Page 49: ......