02
03
01
Introduction
02
Specification
Thank you for purchasing SOLTAB Urban Lighting Products.
Important
Please read these instructions before installation to ensure optimum results
and longevity of your lights. The solar panel should be charged in full
sunlight for 8 to 9 hours before initial first use to provide optimum results.
Features
• Change the operating modes using the silicon rubber on/off button.
• The light can be used separately or connected to the solar panel
with the water tight quick connector
• Use outdoor as a flood light or wall pack
• Use indoor as a desk light or emergency light
• Use as a portable work light or camping light
• Use as your power bank with solar recharging and a USB port
• Tempered-glass laminated, reliable and durable for portable
usage. Double-sided solar panel achieves a higher
conversion efficiency.
• Tools-free rotator enables solar panel angle adjustment or
light direction adjustment, with just bare hands
• Clear Indicator of Battery Capacity: 25% 50% 75% 100%. It
quickly shows the battery capacity at any time. Enables better
planning for your activities
• Lenses for superior optical control, enhanced lighting efficiency
and reduced glare
Notice & Warning
1. The SOLTAB will provide optimal usage where there is
enough sunshine.
2. Please note the lighting time depends on sunshine duration
and weather.
3. The lamp will light up automatically at dusk.
4. Built-in intelligent IC is with over-charge, over-discharge
and over-voltage protection.
5. The lamp is equipped with an internal battery pack, which is
replaceable. If needed, please contact for correct new battery pack.
6. If the battery is taken out and put back in or replaced with new
batteries, please allow the solar panel to receive maximum sunshine
to activate the lamp.
7. Non-professionsals please do not disassemble the lamp.
8. Please do not dispose the battery with household garbage to
avoid explosion.
Please Note
During continuous rainy or cloudy days, run time may be reduced as
the battery will not be fully charged.
Ordering Information Chart
SOL
TAB
10W
4 Operating Modes
90° / 16–26 ft
10W
Mono-Crystalline 6V 10W
27WH 3.7V 7.2AH
1,100
PC & Aluminum
100 lm/W
7hrs (1000W/m
2
)
2–3 Days
-5 °F to 113 °F
32 °F to 149°F
LED Nominal Power
Solar Panel
Lithium Ion Battery
CCT
Lumen Output@4000K
IP65
Beam Angle
Waterproof Rate
> 70
Solar Panel: 13.6 X 8.1 X 0.8 Inches Light: 9.1 X 6.5 X 1.3 Inches
90°
4,000K & 5,000K
CRI
Casting
Efficiency@4000K
Product Size
*
Charging Time
Run Time (@Full Power)
Operation Mode
PIR Sensor Angle / Distance
*
Operating Temperature
*
Charging Temperature
* The temperature can impact the battery’s charging and normal operation.
* The solar charge time data is base on 77 degree F ambient temperature with the
panel pointed directly at the solar radiation. The standard radiation value is 1000W/m
2
.
SOLTAB
10W
Specifications
STL-TAB
=SOLTAB
SERIES
WATTAGE
COLOR
TEMPERATURE
MOUNTING
OPTIONS
FINISH
10
=10W 1000 Lumens
4
=4000K
5
=5000K
WM
=Wall Mount
BK
=BLACK
-
-
-
-
9.1 inches
1.3 inches
6.
5 inches
13.6 inches
8.
1 inches
0.8 inches
