02
03
01
Introduction
02
Specification
Thank you for purchasing SOLPAD Urban Lighting Products.
Important
Please read these instructions before installation to ensure optimum results
and longevity of your lights. The solar panel should be charged in full
sunlight for 8 to 9 hours before initial first use to provide optimum results.
Features
• Solar panel bracket is 360° adjustable and the light module is
135° adjustable. The Adjustable solar panel angle enables
maximizing sunlight collected and allows snow to slide off.
• Large battery capacity of 7200mAh enables long run times.
• Wall-mounting and post-mounting accessories available
• The latest advanced Li-ion battery lasts 2000+ charging cycles
• 3 operating modes that are programmable via remote control or
controls on the fixture
• IP65 rated protection from water, dirt, and dust.
• The easiest way to bring lighting to any outdoor application
• Photo and motion sensors, wide angle 180° detection, high sensitivity
• Wall-mounting and post-mounting accessories available
Notice & Warning
1. The SOLPAD will provide optimal usage where there is
enough sunshine.
2. Please note the lighting time depends on sunshine duration
and weather.
3. The lamp will light up automatically at dusk.
4. Built-in intelligent IC is with over-charge, over-discharge
and over-voltage protection.
5. The lamp is equipped with an internal battery pack, which is
replaceable. If needed, please contact for correct new battery pack.
6. If the battery is taken out and put back in or replaced with new
batteries, please allow the solar panel to receive maximum sunshine
to activate the lamp.
7. Non-professionsals please do not disassemble the lamp.
8. Please do not dispose the battery with household garbage to
avoid explosion.
Please Note
During continuous rainy or cloudy days, run time may be reduced as
the battery will not be fully charged.
Ordering Information Chart
SOLP
AD
10W
10W
Mono-Crystalline 5.5V 6W
27WH 3.7V 7.2AH
1,000
LED Nominal Power
Solar Panel
Lithium Ion Battery
CCT
Lumen Output@4000K
Beam Angle
> 70
11.8 X 7.7 X 1.4 Inches
90°
4,000K & 5,000K
CRI
Product Size
3 Operating Modes
180° / 16–26 ft
PC & Aluminum
100 lm/W
7hrs (1000W/m
2
)
2–3 Days
-5 °F to 113 °F
32 °F to 149°F
IP65
Light Panel: 135° Adjustable Braket: 360° Adjustable
Waterproof Rate
Light Panel
& Braket
Casting
Efficiency@4000K
*
Charging Time
Run Time (@Full Power)
Operation Mode
PIR Sensor Angle / Distance
*
Operating Temperature
*
Charging Temperature
* The temperature can impact the battery’s charging and normal operation.
* The solar charge time data is base on 77 degree F ambient temperature with the
panel pointed directly at the solar radiation. The standard radiation value is 1000W/m
2
.
SOLPAD
10W
Specifications
STL-SFL
=SOLPAD
SERIES
WATTAGE
COLOR
TEMPERATURE
MOUNTING
OPTIONS
FINISH
10
=10W 1000 Lumens
4
=4000K
5
=5000K
WM
=Wall Mount
LP
=LAMP-POST MOUNT
BK
=BLACK
-
-
-
-
11.8 inches
1.4 inches
7.7 inches
