060
061
1.
On/Off
2.
Connect/Test
4.
20%~80% Motion
Sensor Mode (Default)
6.
Early Bird Mode
8.
70% Constant Mode
10.
Timer Mode Disabled
12.
Timer Mode 8 Hours
3.
40%~100% Motion
Sensor Mode
5.
Night Owl Mode
7.
100% Constant Mode
9.
40% Constant Mode
11.
Timer Mode 4 Hours
1. On/Off
When off is selected, the light will stop working. The solar panel will not
charge the battery and the battery will not supply electricity to the light.
2. Connect/Test
Remote control device can be connected with any lighting fixture, one
at a time. To connect, press the button once. It also functions as a test
button. To test, press the “Test” button once, the red light will indicate
the fixture is charging, green light indicates that the fixture is operating.
Testing lasts for 10 seconds, and then it goes back to the mode previously
in use.
When using the remote for the first time, please remove the plastic
piece at the bottom to make the remote turn on.
The range of the remote control to the
indicator is 16ft (Day time) to 33ft (Night
time). Because the sunlight will impact
the signal of the remote control, we suggest
our users to setup the mode before they
install the light.
REMOTE CONTROL GUIDE
16ft–33ft
3. 40%~100% Motion Sensor Mode
Constant 40% brightness (turns on at dusk, turns off at dawn);
100% brightness turns on for 2 minutes when motion is detected.
4. 20%~80% Motion Sensor Mode (Default)
Constant 20% brightness (turns on at dusk, turns off at dawn);
80% brightness turns on for 2 minutes when motion is detected.
5. Night Owl Mode
Changes as natural light decreases/increases (turns on at dusk); 70%
brightness for 0.5 hour, 100% brightness for 3.5 hours, 70% brightness
for 1 hour, 50% brightness for 1 hour, 20% brightness for 5 hours
(turns off at Dawn).
6. Early Bird Mode
Changes as natural light decreases/increases with increased brightness
near dawn for early risers (turns on at dusk); 70% brightness for 0.5
hour, 100% brightness for 3.5 hours, 70% brightness for 1 hour, 50%
brightness for 1 hour, 20% brightness for 4 hours, 100% brightness
for 1 hour (turns off at Dawn).
Important
Dusk and dawn time can vary for different locations and seasons.
The sensors in our products will monitor the light levels where it is
installed. The time period shown in the chart above is just an example
to help you understand the different lighting modes.
(IAP) Intelligent Adaptive Program Battery Control Technology
In order to extend the off-grid autonomy of solar products under
shade trees, heavy rain, and thick clouds, our controllers now
integrate an adaptive smart control feature to actively track battery
capacity and adjust light output accordingly. Before integrating this
feature, selecting a light output percentage on the remote would
yield an accurate percentage of max LED brightness. Activating
the IAP, the controller actively monitors the battery and regulates the
electrical current to the LEDs. The controller makes the light output
of a selected percentage on the remote relative to battery capacity
rather than max LED output. This smart-control feature can increase
the fixture’s off-grid performance by up to 40%.
