010
03
Installation and Wiring Requirements
1. Installation and wiring must comply with the State and National
Electrical Codes.
2. The SUNLIKE, FLUX, BEACON and SOLPAD models are intended
for outdoor use only and should not be installed in an unventilated
area, and must be installed in an environment within the operating
temperatures defined for the product.
3. The average sunshine in the installation area should be above
3.5 hours/day in order to ensure full function of the light fixture.
Avoid areas with shade.
4. Before installation, if applicable, please ensure the light pole and its
foundation are stable enough to withstand the lighting fixture(s).
5. Before installation, please ensure that the battery is fully charged. Install
during sunny days if possible.
6. Before installation, press the ON/OFF key on the remote control(if
it has)and check whether it shows a red light on the indicator.
Cover the solar panel and check if the light module turns on normally
within 1 minute.
After Installation
The light fixture will automatically turn on at night and turn off
during daylight.
Important
Always orient the solar panel facing the equator (e.g. facing south if in
northern hemisphere).
Always have a tilt angle of at least 15° to avoid dust accumulation
(0°=horizontal plane).
