08
09
04
Luminous Distribution
Cegonia
8W
Cegonia
20W Type III
Cegonia
30W Type III
Battery pack
Battery pack screws
Solar panel
1. The LiFePO
4
-battery-powered Satelis lights are visibly brighter
than other outdoor solar lights, and their performance overall is
more reliable.
2. To charge the battery fully may take up 6 to 12 hours.
3. Output will be reduced to 40% when the battery is below 40% of
its capacity.
4. Battery will stop charging when the ambient temperature is below
32°F or above 149°F.
Battery Status is indicated by the red/green indicator on the lighting
fixture as follows:
- Red indicator (Charging)
> Slow red light flashing = Charging
> Red light continuously on = fully charged
> Quick red flashing = charge fault
- Green indicator (not charging)
> Green light continuously on = more than 40% of the battery
capacity remaining
> Slow green light flashing = battery capacity below 10%
> Quick green light flashing = battery below 0% mode—Protect
battery does not over discharging
Storage
To avoid over discharge of the battery during storage, please recharge
the lighting fixture every 4 months. Use the dedicated charger to charge,
reset the switch when done.
Battery Replacement
1. Disconnect the
wire connectors.
2. Loose the screws of the
battey pack and take out
the battey pack.
3. Replace a new one.
4.Tighten the screws of
battery pack.
5. Connect the wire connectors
(Be sure you match the color
when you connect them).
(IAP) Intelligent Adaptive Program Battery
Control Technology
In order to extend the off-grid autonomy
of the Cegonia under shady trees, heavy
rain, and thick clouds, our controllers now
integrate an adaptive smart control feature
to actively track battery capacity and adjust
light output accordingly. Before integrating
this feature, selecting a light output percent-
age on the remote would yield an accurate
percentage of max LED brightness. Now with
(IAP), the controller actively monitors the
battery and regulates the electrical current
to the LEDs. The controller makes light output
of the selected percentage on the remote
relative to battery capacity rather than max
LED output. This smart-control feature can
increase our off-grid performance by up
to 40%.
05
Battery Notes
Disconnect wires
Loose the screws
of the battery
pack and take out
the battery pack.
Replace new
battey pack
and tighten
the screws.
01
02
03
