![Soltech CEGONIA 8W Installation Manual Download Page 4](http://html.mh-extra.com/html/soltech/cegonia-8w/cegonia-8w_installation-manual_1316843004.webp)
04
01
Introduction
Thank you for purchasing CEGONIA Urban Lighting Products.
Introduction
CEGONIA combine stylish design with hight efficiency. You can adjust both
the tilt angle and the azimuth to make sure the panel is in the optimal
position to capture the sun’s energy. It is a perfect fit for courtyards, parks,
schools, communities and paths.
Important
In order to avoid deep discharge of the battery during storage, please
fully recharge your battery every 4 months. Please make sure that the
light is installed in an area with sufficient sunlight irradiance. A strict
minimum of 3.5 hours/day of sunshine on average is recommended. Se-
lect the right operating mode according to the local legislation needs and
the local sunshine conditions. Keep it away from shadows. Self-cleaning
available when the light fixture have minimum angle of 15 degrees.
Please save these instructions. Read all of the instructions carefully
before attempting to carry out any installation or wiring. Do not open or
attempt to repair the product on your own, as it many cause serious
damage and would void the product warranty. Contact your local
distributor for any questions concerning the installation.
Range of the light module on the lighting fixture is 20–26 feet
(6–8 meters). The ideal installation spacing is >16 feet(5 meters). When
installing two or more lighting fixtures on one pole, select desired
operating mode before installation. Interference can cause delay or
malfunction when using the remote control to change operating modes
after installation.
Precautions when working with solar panels
When the solar panel is exposed to sunlight, a voltage appears at the
output terminals of the solar panel turning it into a source of electricity.
To avoid a shock hazard, make sure the solar panel is covered with an
opaque (dark) later such as paper or cloth during the installation. Do not
make contact with the terminals when the panel is exposed to sunlight or
any other light source.