11
•
Step 2: Connect the regulator to the gas cylinder,
following the instructions for your regulator
accordingly. Don’t force the regulator as this could
damage the gas cylinder or regulator fitting.
CONNECTING THE LIQUID PROPANE CYLINDER
To connect the Liquid Propane gas supply cylinder: The
cylinder valve should be in the “OFF” position. If not, turn
the valve clockwise until it stops. Make sure the cylinder
valve has the proper external male thread connector
fitting to Type 27 and cylinder certified with AS 2469. Make
sure the burner valves are in the “OFF” position. Inspect
the valve connections and regulator assembly to the valve,
use your hand to tighten the nut clockwise until it stops.
Use of a wrench could damage the quick coupling nut and
result in a hazardous situation. Open the cylinder valve
fully by turning the valve counter-clockwise. Before lighting
the burner, use a soap and water solution to check all the
connections for leaks. If a leak is found, turn the cylinder
valve “OFF” and retighten connection. If leak persists then
do not use the oven until a local Liquid Propane dealer can
make repairs.
Clockwise
WARNING!
1. Do not store a spare LP gas cylinder under or near this
appliance.
2. Never fill the cylinder beyond 80 percent full
3. If the information in item 1&2 is not followed exactly,
a fire causing death or serious injury may occur.
CAUTION: Place dust cap on cylinder valve outlet
whenever the cylinder is not in use. Only install the
type of dust cap on the cylinder valve outlet that is
provided with the cylinder valve. Other types of caps
or plugs may result in leakage of propane.
WARNING
DO NOT USE AN ADAPTOR AT THE CYLINDER
CONNECTION
DISCONNECTING THE GAS
After cooking, turn off the gas from the gas cylinder
before turning off your Pizza Oven. This will allow any
gas left within the burner and/or hose assembly to be
used up safely.
Once the flames are fully extinguished within the pizza
oven (upto 2 mins), you can rotate the Pizza Oven control
knob to the off position (clockwise).
It is now safe to disconnect the Regulator and hose
assembly from your gas cylinder.