Getting Started
1. Download the software from:
and install Levelogger Software on your PC.
2. Install the Wellhead batteries. The Wellhead uses 4 user-
replaceable 1.5V AA lithium batteries.
3. Connect the Wellhead and logger to the Vented Cable:
Support
Hanger
Bracket
- 2 -
Note:
Note:
See page 6 for instructions to install the Support Hanger
See page 6 for instructions to install the Support Hanger
Bracket, as shown at right.
Bracket, as shown at right.
Note:
Note:
For information on using your AquaVent 5 logger with
For information on using your AquaVent 5 logger with
MODBUS or SDI-12 protocols, see separate User Guides.
MODBUS or SDI-12 protocols, see separate User Guides.
Battery
Compartment
SP
Wellhead
Vented
Cable
AquaVent 5
Logger
10-Pin (SP)
Connection
Line up the socket and the pin. Gently push the Wellhead and Vented
Cable together and twist slightly until you feel/hear a small click when
the properly aligned connection is made.
Only tighten the stainless steel coupling
while holding the Vented Cable
and Wellhead still. Tighten the coupling until it seats. Do not twist the
Vented Cable or Wellhead.
Follow the same procedure when connecting the logger to the Vented
Cable.
Well Cap
Base
Vented Cable
alignment socket
Wellhead and logger
alignment pin
Only Turn Coupling
Hold Vented
Cable Still
Hold
Wellhead
Still
