EN
User manual for LED outdoor floodlights
Dear customer, thank you for purchasing our product. For its safe and full functioning, please read these
instructions carefully and adhere to them to avoid product misuse or damage. Please prevent unauthorized
use of this appliance and always observe all rules for using electric appliances. Keep these instructions for
future reference. The installation must be performed by qualified personnel only.
This user manual is for: WM
-
10WS
-
E, WM
-
20WS
-
E, WM
-3
0WS
-
E, WM
-
50WS
-E
, WM
-
50WS
-F
Installation
•
Before starting installation, during maintenance or disassembly, the power must always be
disconnected by turning off the switch or circuit breaker.
•
The lamp heats up when it is on. Before performing any work with the lamp, e.g. maintenance, the
lamp must always be disconnected from the power supply and left for a few minutes to cool down
completely.
•
The lamp must not be used without the protective glass or if the protective glass is cracked.
•
The lamp must be connected to the electrical system with a three
-
wire cable (with a protective
conductor), which must be fed into the lamp through the cable gland.
•
The lamp must be connected as shown in Picture 1.
L=phase=brown cable
N=
neutral = blue cable
Earth = green
-
yellow cable
•
It is essential to check that the wiring is connected properly before first using the lamp.
•
Before fixing the lamp in place, check that the lamp is sufficiently far away from nearby objects; the lit
object must be at least 1m away from the protective glass
–
see Picture 2.
•
Suitable for a power cable 9
-
12mm in diameter.
•
Finally, tighten all screws and adjust the lamp bracket to achieve the desired lighting effect.
Caution:
Keep out of reach of children; do not tamper with wiring. Technical changes are reserved; keep this
manual in a safe place.
Setting the sensor and lighting time
:
The knobs on the bottom
of the sensor can be used to set 3 parameters of the sensor:
•
SENS:
Sets the sensitivity of the motion detector.
•
TIME:
Sets the lighting time.
•
LUX:
Sets the switch sensitivity in relation to ambient light conditions.
SOLIGHT Holding, s.r.o. is in no way liable for damaged caused by improper installation of the lamp,
improper electrical wiring, the use of other than the recommended accessories, unapproved technical
changes, or failure to comply with the recommendations in this manual!
Manufacturer
:
Solight Holding, s.r.o., Na Brně 1972, Hradec Králové
500 06, Česká republika
Sensor range: max. 9m (up to 24°C)
180°
Lighting time: 5s
–
4 min.
Pic 1
Pic 2
