EN
Outdoor LED reflector lamp
Type: WM-10W-M – power: 10W
Type: WM-20W-M – power: 20W
Type: WM-30W-M – power: 30W
Dear customer,
Thank you for purchasing this outdoor LED lamp.
Read and follow these instructions carefully to assure that your product is used safely
and to your complete satisfaction!
Usage:
•
the lamp is designed for lighting open spaces, especially industrial areas and
around homes
•
easy to install
•
gives out a clear, intense light
•
effectively discourages unwanted visitors
Installation:
WARNING!
•
Before starting installation, during maintenance or disassembly, the power must
always be disconnected by turning off the switch or circuit breaker.
•
Work associated with connecting the lamp to the power supply should be
performed by an appropriately competent person.
•
The lamp heats up when it is on. Before performing any work with the lamp, e.g.
maintenance, the lamp must always be disconnected from the power supply and
left for a few minutes to cool down completely.
•
The lamp must not be used without the protective glass or if the protective glass is
cracked
.
•
The lamp must be connected to the electrical system with a three
-
wire cable (with
a protective conductor), which must be fed into the lamp through the cable gland.
•
The lamp must be connected as shown in Picture 1
.
L=phase=brown cable
N=
neutral = blue cable
Earth = green
-
yellow cable
•
It is essential to check that the wiring is connected properly before first using the
lamp
.
•
Before fixing the lamp in place, check that the lamp is sufficiently far away from
nearby objects; the lit object must be at least 1m away from the protective glass
–
see Picture 2
.
•
Suitable for a power cable 9
-
12mm in diameter.
•
Finally, tighten all screws and adjust the lamp bracket to achieve the desired
lighting effect.
Troubleshootin
g:
If the lamp does not light up, first check the power supply.
Caution:
Keep out of reach of children; do not tamper with wiring. Technical changes are
reserved; keep this manual in a safe place.
The light source of this luminaire is not replaceable; when the light source reaches its
end of life the whole luminaire shall be replaced.
SOLIGHT Holding, s.r.o. is in no way liable for damaged caused by improper
installation of the lamp, improper electrical wiring, the use of other than the
recommended accessories, unapproved technical
changes, or failure to comply with the
recommendations in this manual!
Manufacturer:
Solight Holding, s.r.o., Na Brně 1972,
Hradec Králové 500 06
Type: WM-10W-M
Power: 10W; Voltage: 220
-
240V,
50/60Hz
Light source: LED 10W;
Luminous flux: 750lm
Chromaticity: 4000K; Material: Die
-
cast
aluminium
IP65
WM-20W-M
Power: 20W; Voltage: 220
-
240V,
50/60Hz
Light source: LED 20W;
Luminous flux: 1500lm
Chromaticity: 4000K; Material: Die
-
cast
aluminium
IP65
WM-30W-M
Power:
3
0W; Voltage: 220
-
240V,
50/60Hz
Light source: LED 20W;
Luminous flux: 2250lm
Chromaticity: 4000K; Material: Die
-
cast
aluminium
IP65
Picture
1