Technical Specification
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. Changes or modifications not expressly approved by SolidRF could void the authority to operate
this equipment.
RF Exposure: The manufacturer’s rated output power of this equipment is for signal carrier operation. For situations
when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, especially where the output
is reradiated and can cause interference to adjacent band users. This power reduction is to be by means of input
power or gain reduction and not by an attenuating at the output of the device.
Frequency
(MHz)
Cellular
( band5)
PCS
(band
25/2)
Uplink
824-849 1850-1915
Downlink
869-894 1930-1995
Gain
Uplink
62±2
65±2
Downlink
65±2
68±2
Output power
23±2dBm(Uplink)/0±2dBm(Downlink)
Noise figure
<3dB
In-band Flatness
<5dB
Weight
0.7Kg
EIRP
1W
Gain adjustment
20dB
Impedance
50 ohm
Operating
temperature
-20
℃
to +50
℃
Current
≦
1.5A(12V DC)
Dimension(mm)
155*125*25
This is a CONSUMER device.
BEFORE USE,
you
MUST REGISTER THIS DEVICE
with your wireless provider and have your provider’s
consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent
to the use of this device on their network. If you are unsure, contact your provider.
You
MUST
operate this device with approved antennas and cables as specified by the manufacturer.
Antennas
MUST
be installed at least 20 cm (8 inches) from any person.
You
MUST
cease operating this device immediately if requested by the FCC or a licensed wireless service
provider.
WARNING
. E911 location information may not be provided or may be inaccurate for calls served by
using this device.
WARNING:
