Power supply
6-24 VDC
l
• www.solidmation.com | [email protected]
l
www.solidmation.com |
l
www.solidmation.com | [email protected]
1.
Turn off power and dismantle the box where the
push-button will be installed.
2.
Dismantle the box containing the push-button
controlling the LEDs.
Wiring:
3.
Connect the LED power supply to the “+” and “-”
terminals of the module.
4.
Connect push-buttons to the input channel: input
channel 1 between terminals “C” and “1”; input
channel 2 between terminals “C” and “2”; input
channel 3 between terminals “C” and “3”.
Note: the interconnection between the push buttons
and “C” terminal is done outside the module.
5.
Connect monochrome LED at the outputs “R” in
“Channel 1”, “G” in “Channel 2”, “B” in “Channel 3”.
6.
Connect the anode of the monochrome LEDs to
“+”.
7.
Note: the three anodes must be interconnected
outside the module.
8.
Check that connections are done according to
Diagram “A”.
9.
Mount the switch frame and cover.
10.
Run Habeetat Planner software and follow the
instructions for proper configuration of your device.
Procedure for proper installation
Congratulations, your equipment is now ready to be
configured using Habeetat Planner software.
Solidmation S.A. | All rights reserved. Subject to changes without prior notice.
+
+
+
