l
• www.solidmation.com | [email protected]
l
www.solidmation.com |
l
www.solidmation.com | [email protected]
1.
Turn power off.
2.
Dismantle the box containing the toggle / push-
button to control light fixtures.
Procedure for proper installation
3.
Confirm there is a neutral wire and a supply line
wire to supply power to toggle/push-buttons,
otherwise you will have to install the missing wire.
4.
In already existing installations, disconnect the
wires from the toggle/push-button.
Wiring:
5.
HPA-2140 and 2130: Connect Red, Blue and Black
wires, coming from the In-wall module switch to the
toggles or push-buttons.
6.
Connect neutral and line wire to the input terminal
of the In-wall module switch.
7.
HPA-2140 and 2130: Connect the wire
corresponding to the load to be controlled, which
will be triggered by toggle No.1, at output No. 1.
Proceed the same way with the connection for the
second lamp for the output No. 2.
8.
Check that connections are done according to
Diagram “A”.
9.
Carefully place the switch at the bottom of the box,
on a vertical position if possible.
10.
Mount the switch frame and cover.
Congratulations, your equipment is now ready to be
configured using Habeetat Planner software.
Solidmation S.A. | All rights reserved. Subject to changes without prior notice.
