PRODUCT MANUAL
RGB NeonMini 24V 60W
Toll Free. 425-582-7533
www.SolidApollo.com
page 5
™
Technical Information
1. Do
- Check the length of the cable wires before soldering to avoid having to cut and re-solder the cables. Remember, if the
cables are not a proper length the connection will not be waterproof sealed.
2. Don’t
- Do not forget to slide the Cable End Cap onto the cable wire first before soldering your connections (refer to Step 4).
Do’s and Don’ts
Before Soldering Cable Wires to RGB NeonMini
Proper Handling and Cutting
1. Do -
Always double-check the cut point you are preparing to cut. Highlight it with a marker if you have to, it’s better
to be safe than sorry.
2. Don’t -
Keep in mind that the RGB NeonMini is side bending (left to right) in the opposite direction of the light
output and not top bending (up and down). Bending the RGB NeonMini vertically could split the contacts causing
the unit to fail. If you do have to adjust the RGB NeonMini vertically, off the brackets for example, pull the unit off
the brackets gently.
Dimmable :
Minimum Cut :
Total LEDs :
LEDs per Foot :
Operating Voltage :
Watts per Foot :
Watts per Spool :
Max Power :
Yes
2in (50mm)
720
36
24V
3W
60W
60W
LED Type :
Beam Angle :
Warranty :
Weight :
Size :
IP Rating :
Working Temperature :
SMD 3838
111º
3 Years
1.55lb
L: 19.7ft x W: 0.23in x H: 0.47in
IP67
-10F to 140F
