PRODUCT MANUAL
Magro RGB-W Wireless LED Wall Controller / Wall Switch
Contact Us: 425.582.7533
www.SolidApollo.com
page 3
™
Product Wiring and Installation
Wiring of Receiver
Wiring of Solid Apollo’s 5A Wireless Receiver is easy and straightforward.
The tools required for the installation are Philips head screwdriver, slot head screwdriver and wire strippers.
Unscrew and remove the white plastic endcap to expose the
green wiring terminal blocks.
Step 1:
To add power, strip off about ¼-inch
of the plastic jacket from the ends
of the power supply wires to expose
the metal strands. Twist each wire to
bind the strands together for a better
installation.
Please Note:
Make sure that the
power supply is NOT connected to a
power source.
Step 2:
Open the green terminal-block slots located below the
screw, by partially unscrewing the screws on the top.
Step 3:
Securely install the stripped Power
Supply wires into the opened
“
INPUT
” side of the terminal-block
by tightening back the screw until
the wires are firmly installed. The Red
wire should be connected to the “+”
slot of the “INPUT” and the Black wire
connected to the “-“ slot.
Step 4:
Strip off ¼” of the wires from the LED fixture and connect them to
the “
SEC
” side of the terminals by similarly following Steps 2 and 3.
The positive wire of the fixture can be connected to any of the “+”
terminals and the negative wires according to color (Red to Red, Blue
to Blue, and so on).
Lightly pull the wires to test and make sure that they are strongly
connected. Place back the end cap removed in step 1. Wiring is
complete and you can now power up.
Step 5:
