Problem
Possible Causes
Solutions
Water on the floor
Hose connection may be loose.
Check the hose connection. See the
CONTINUOUS MODE
-
GARDEN HOSE INSTALLATION AND SET UP
Section on
Page 12.
Hose is attached but not draining
into a drain
Disconnect the hose if using the bucket or place the hose near
a drain.
Unit will not turn on
The fuse is blown / circuit break-
er is tripped.
Check the house fuse / circuit breaker box and replace fuse or
reset breaker.
Unit is on but fan is not
running
Dehumidifier has reached its
present level or the bucket is full.
The dehumidifier automatically turns off when either condi-
tion occurs. Change to a lower setting or empty the water
bucket and replace properly.
Bucket is not in the proper posi-
tion.
The bucket must be in place and securely seated for the dehu-
midifier to operate.
Power Failure.
There is a protective time delay (up to 3 min.) to prevent trip-
ping of the compressor overload. For this reason, the unit may
not start normal dehumidification for 3 min. after it is pow-
ered back on.
Pump Mode is on, but water is
draining in bucket
Incorrect drain hose is installed
Make sure that the included plastic drain tube and nozzle
adapter are tightly installed.
Continuous Mode is on, but
water is draining in bucket
Incorrect drain hose is installed
Garden hose must be used while operating Continuous Mode.
Dehumidifier on uneven surface
Make sure that the unit is placed on a flat, level surface.
TROUBLESHOOTING
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
The distance between user and device should be no less than 20cm.
