Soleus Air AQUA SUB Aqua Sub MW-59, Owner'S Manual, Page: 6 / 9

1. Make sure the water dispenser is not plugged into
an electrical outlet.
2. Open the door of the lower cabinet and pull the tray
out from the cabinet.
3. Place a full water bottle on the tray. Remove the
plastic cover over the mouth of the water bottle.
4. Put the hose inside the water bottle and place the
water bottle cap firmly over the mouth of the water
bottle. (Figure 1)
5. Push the tray inside the cabinet of the water cooler.
Attach the hose to the water cooler by pressing in
on the knob of the hose cap and sliding over the
connector at the top of the cabinet.
Push up firmly
to assure the connection is tight. (Figure 2)
6. Close the lower cabinet door.
7. Plug the water cooler into a grounded power outlet
and turn on the power switch located on the back.
8. The unit will start to operate, but you should wait at
least half an hour before using the water cooler.
NOTE: If there is not a secure connection between the hose cap and the connector on the
water cooler, the water pump will operate but the water cooler will not dispense water.
Make sure the hose is connected to the water cooler correctly.
NOTE: Please wait until the water pump stops running before using the unit. If the water tank is
not full, no water will dispense from the tepid water faucet and the hot water faucet.
NOTE: The second time the water bottle is changed after the light on the front panel is on,
switch RESET to OFF for 3 seconds.
OPERATION
After the water bottle has been connected to the water cooler, the unit is ready for use. Turn the
power switch on the back of the unit to ON. The water cooler will start running. First the unit
will pump the water from the water bottle into the cooling and heating tanks, and then the unit’s
compressor and heater will start to operate. The first time the water cooler is used, you will have
to wait at least half an hour for hot and cold water.
When the indicator light on the front panel is on, there is no water left in the water bottle. The
water bottle will need to be replaced. Replace the water bottle, and then press the RESET button
located on the backside of the unit. The water cooler will work again and the indicator light will
be off.