ERV
TRC800 & TRC800V
9
1.800.961.7370
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
WWW.SOLERPALAU-USA.COM
INSTALLATION
INSTALLATION
SIngle phase ECM motors are NOT suitable for use
with solid state speed control. They already have
speed control built into the motor electronics.
Moteurs d’une phase de l’ECM ne conviennent pas pour
une utilisation avec regulateur de vitesse electronique.
Ils ont déjà le contrôle de vitesse intégré dans le moteur
électronique.
ELECTRICAL SPECIFICATIONS
Use conduit, strain reliefs, etc. as required by
code to secure the field wiring. Electrical knockouts
are provided for alternate line voltage and voltage
control locations for field wiring to the internal
electrical box. If the alternate sites are desired for
field wiring then carefully remove the knockout
plugs and foam insulating plugs from the alter-
nate sites and install them in the open knockout
locations.
NOTE:
If your unit is equipped with EC Motors,
please refer to “EC Motor Manual Supplement” for
more detail.
WARNING
Secure the TRC800 or TRC800V with straps or
clamps so that it cannot fall or tip in the event of
accident, structural failure or earthquake.
WARNING
The TRC800 weighs 210 lbs. and the TRC800V
weighs 207 lbs. It is the installer’s responsibility to
make sure that the screws or bolts used for securing
the units are properly selected for the loads and
substrates involved.
CAUTION
INSTALLATION INSTRUCTIONS