2nd Time: 0~ 15hrs
2nd Power: 0~ 100%
3rd Time: X
3rd Power: 0~ 100%
Time Duration begins after 1
st
Time Duration is complete, set hours and
output you would like the light to behave when motion is sensed. The
motion sensor will stay active for 30 seconds unless motion is still active
Default, please ignore
Set the power output when motion is idle during the 2
nd
Time duration,
no motion detected output
M Time: X
Set Pre-Dawn Time 0
～
15 hours
Set Pre-Dawn Power 0
～
100%
*The motion sensor is disabled during this period
*You can leave the values 0 here, unless you would like a constant output
added into the custom scheme
M Power: X
3
rd
Time: X (Default cannot be
changed)
3
rd
Power: 50% (Applied to 2
nd
Time Power when idle
For the first 2 hours the product runs at 80% output, the next 12 hours after the first 2, it will
run it at 50% idle & 80% when motion is sensed until dawn. The motion sensor output stays
on for 30 seconds unless motion is still detected.
2
nd
Time: 12
2
nd
Power: 80%
1st Time: 2
1
st
Power: 80%
M Time: 0
M Power: 0%
Time Control Mode w/ motion
Default runtime scheme below.
Can be adjusted following instructions above