OPERATION
1. Plug cord into any 120 Volt 60 HZ outlets.
2. Rotate the thermostat control knob clockwise to high position.
3. Set the selector switch to desired position. Use High (1500W) setting to raise
the temperature quickly. For reduced output, flip the selector switch to LOW
(900W).
4. Slowly turn the thermostat knob counter clockwise until the heater shut off. The
heater will automatically maintain this temperature, for a lower temperature.
Rotate the knob further counter clockwise. For a higher temperature, rotate the
knob clockwise.
5. Power light remains on when the heater power supply cord is plugged into an
electrical outlet and operated well. (Note: The heater would cycle “on”
automatically if the room temperature drops below the thermostat control
setting.)
This appliance has a 3 prong grounded plug that must be inserted into reduce
the risk of electrical shock.
Note
：
This unit has FAN only setting which helps you to cool down the unit
before you turn it off.
Note
：
Always unplug the heater when not in use
6. To disconnect heater, turn the thermostat control to off, then remove plug from
outlet.
ATTENTION: This heater is equipped with an automatic overheat safety device. If
temperature of the heater becomes too high, the automatic device will turn OFF the
motor and heating elements and turn on the red light marked “CAUTION”.
A
B
C
D
F
E
G
A- Power light
B- Caution light
C- Warm outlet opening
D- Selector switch
E- Thermostat knob
F- Carry handle
G- Body
