S73 / S77
22
Calibration procedure:
1) Remove the safety key
2) Press and hold down the Start and Fast (speed up) buttons with one hand and replace the safety key
with the other. Continue to hold the Start and Fast key until the window displays “Factory settings”,
then press the enter key.
3) You will now be able to set the display to show Metric or English settings. To do this, press the up or
down key to show which you want, then press enter.
4) Make sure the wheel size diameter is 2.83 then press enter
5) Adjust the minimum speed (if needed) to 0.5 and then press enter
6) Adjust the maximum speed (if needed) to 12.0 and then press enter
7) Adjust the maximum elevation (if needed) to 15 and then press enter
8) Press start to begin calibration. The process is automatic; the speed will start up without warning, so
do not stand on the belt.
Adjusting the speed sensor:
If the calibration does not pass you may need to check the speed sensor alignment.
1) Remove the motor cover hood by loosening the 4 screws that hold it in place (you do not need to
remove them completely).
2) The speed sensor is located on the left side of the frame, right next to the front roller pulley (the
pulley will have a belt around it that also goes to the motor). The speed sensor is small and black
with a wire connected to it.
3) Make sure the sensor is as close as possible to the pulley without touching it. You will see a magnet
on the face of the pulley; make sure the sensor is aligned with the magnet. There is a screw that
holds the sensor in place that needs to be loosened to adjust the sensor. Re-tighten the screw when
finished.
Maintenance menu:
1) Press and hold the Start, Stop and Enter key at the same time, until the display shows “Engineering
mode” (it may say maintenance menu, depending on version). Press the Enter key.
2) You can now scroll through the menu using the up and down keys. Use the Stop key to return to
previous menu selection. The menu selections are:
1)
Calibration
(used to verify calibration)
2)
Factory settings
(These should not be changed unless instructed by Sole service department)
3) Security
(This allows you to lock the console keyboard)
4) Functions
i. Sleep
(turns sleep mode on or off)
ii. Pause
(turns pause mode on or off)
iii. Maintenance
(reset lube message and odometer readings)
iv. Units
(set display to English or Metric readings)
v. Grade
return
(returns the elevation to lowest setting when pause is pressed)
5) Display
test
(lights all LED lights for testing)
6) Key
test
(tests that all keys are functioning)
