SolaX Adapter Box
Quick Installation Guide
Packing List
-
Check that if there is any distortion or impaired during
transportation.
SolaX Adapter box is matched with a heat pump with dry
contact function, which can realize heat pump integrated
photovoltaic inverter energy system management. The inverter
can control the Adapter box to use solar energy efficiently
according to the requirements set by the user (grid power,
battery capacity, time, etc.) Supplying heat pumps is generally
applicable when there is surplus solar energy and battery
storage capacity. This part of the energy can be used to heat
the heat pump within the required temperature range. Please
read this guide carefully before using.
Mounting
III
Introduction
I
-
Dismantle the upper cover of the SolaX Adapter Box.
-
Pass the expansion screws through box installation channels.
Screw
the
expansion screws.
Quick installation
guide X1
Expansion tubes X4
Expansion screws X4
Hot water
Heat pump
8
0
m
m
130mm
112mm
6
2
m
m
Overview
II
φ
6 Drill
(Depth:
30 mm)
IV
6
2
m
m
112mm
-
Use the marking cardboard to x it on the wall and determine the location of the hole.
Drill holes with
φ
6 drill.
Depth: at least 30mm.
-
Tighten the expansion tubes.
Slotted screwdriver
torque:
0.5
±
0.1Nm
V
Connection diagram of the external relay for the Smart Grid Ready control of a heat pump.
(For the dry contact K3/K4 wiring on the heat pump, please refer to the heat pump quick installation guide)
K4
K3
K2
K1
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Inverter
Heat pump
Note:
Adapter Box is usually suitable for heat pumps
with dry contact function. The connection of the Inverter's
communication 3/6/7/8pin dry contact and the dry
contact K3/K4 on the heat pump is controlled.
Wiring
In
ver
ter
Heat pump
K3
K4
01
71mm
N
O
1
2
3
Marking cardboard X1
Note: Please choose a place where the Adapter
box is not directly exposed to the sun.
Heat pump
Slotted screwdriver
torque:
1.2
±
0.1Nm
