the position. In SOLARSAN-SLAVE the same requirements for installation and installation of the current threshold.
The number of SOLARSAN-SLAVE connected to one SOLARSAN-GPS is not limited. The encryption method
provides reliable protection against interference or interference.
Light sensor
It is recommended to use this function, which should reduce the management costs in low light. Set the photo resistor to
a place where there is no shadow. The procedure is best done at sunset or sunrise:
Wait for the SV- "value" in the data line.
Set the value of parameter SP- from 3-255.
The value of SP is compared with SV. If SV> SP, then SOLARSAN-GPS falls asleep.
Configuration
•
Turn off the SOLARSAN power when installing the WiFi module.
•
In the WiFi environment, an access point named SOLARSAN appears. Log in using the password 1234568.
•
Go to address 192.168.4.1 and click the "Configure WLAN settings" link.
•
Select your network from the list and enter the password from it. Click the "Connect" button.
•
The Status value indicates the status of the network connection. IP 192.168.1.73, the one shown below
indicates the address in the local network, by going to which you can also get to the configuration page. It is
recommended to change the password from the SOLARSAN network in order to protect against unauthorized
access.
•
Go to the SOLARSAN configuration page "SOLARSAN_config".
•
Set and save the required settings. After accepting the new parameters, the module reload signal will sound and
the data will take effect. Check the data after the page is refreshed. If the data corresponds to the format, the
module will save them. Use the UPDATE button to update the data. SOLARSAN-GPS Provides data each time
it calculates the average wind speed or 60 seconds.