in base of 3” cup.
Place completed lamp onto existing pole and carefully drive the three fitting screws in fitter base cup, ensuring it attaches to the
pole safely. Caution must be used to not over tighten screws.
OPERATION
Two-way switch: O (OFF) - I (ON.).
Automatically: The light can be turned ON pressing the power switch to I=ON position. Once the switch is in this position, the light will
turn on at night and turn off during the day.
Wireless Remote: The light can also be turned ON or OFF by the wireless remote. The wireless remote will only works when the
power switch is turned ON. The light will still turn itself off automatically during the day if you forget to turn off the light by the wireless
remote after use. Extending the antenna provides greater detection distance for the remote control.
NOTES AND TROUBLESHOOTING
If there is not enough sunlight on the solar panel daily, the unit may not charge. Please ensure that the unit is placed in a
position where there is at least 8-10 hours of sunlight a day.
If there is too much ambient light interference, the unit will not activate as it will assume that it is not dark enough.
Please keep the solar panel clean by wiping it once every few months with a damp cloth or paper towel.
Don’t use strong
detergents or acid based cleaners.
Rainy and cloudy conditions over continuous days will also affect the charging ability of the light.
Please note the unit only charges the battery in the
I
position.
If the light will not illuminate after 2 sunny days, turn on the switch and charge the battery at day time and turn off the switch to
O
position to let the lamp not light. For next day, turn the switch on again. Repeat this step for 3 SUNNY days to ensure battery
is fully charged. On 4
th
morning, return switch to
I
position for normal operation. If the lamp does not illuminate then, the battery
needs to be replaced. NOTE- Lamp does not charge in the O
off position.
BATTERY REPLACEMENT
The battery is 3.7V 2000 mAh Li-ion rechargeable battery which is easily replaceable.
If the battery begins to illuminate dimly or for short durations of time and you know that it has had sufficient sunlight on the panel, you
should replace the battery in the following way:
1. Take off the solar panel cover by removing 2 screws on the solar top.
2. Take off the LED plate by removing 4 screws on the plate without damaging cables.
3. Unscrew the black box at the back of LED plate and change with two new 3.7v 2000 mAh Li-ion batteries.
WARNING
– Polarity is important. Wrong polarity is dangerous and will destroy the unit.
□
UPC: SGG-COACH-FL1-C-F/
857510008206
□
UPC: SGG-COACH- FL1-C-P/
857510008213
□
UPC: SGG-COACH- FL1-C-W/
857510008220
